Installation Guide

Shower Pan Installation Guide - Clamp Ring
Step 1
Remove the four screws and discharge the
white clamp ring. Install a bead of urethane
onto the clamp ring and around each screw
as show in picture two. Screw the adaptor
on using the screws from the clamp ring.
Step 2
Pret the shower pan and cut to t the shower area, if
needed. You can cut the foam board with a utility knife
or a circular saw. Install the cone on the shower pan.
Step 3
Mix a modied thin-set mortar suitable for the suboor as per
manufacturer specication. Use a 3/8” square notched trowel and
apply thin-set mortar to the oor and backside of shower pan. Assure
that the thin-set is troweled in the same direction. Spreading the
thin-set with a square notched trowel will assure full coverage. Set
the shower pan into place.
Step 4
Protect the shower pan by using a double layer of cardboard. Take two
bags of thin-set and place them in the drain area for extra weight to
assure the pan slope stays at a minimum of 2%. The drain cover will be
screwed onto the pan just before tile installation.
Suboor Prep
You must begin with a dry and structurally sound suboor. If water damage, rotting, or any other
structural defects are present, you MUST repair prior to installing your new showerboard. A clean
and level suboor is required for a successful installation. After cleaning the suboor, use a level to
check the suboor. The suboor MUST be level so that the showerboard will drain correctly.
Note: a self-leveling mortar can be used to level the suboor.
[e-mail]800-278-1956