Instructions / Assembly

Installation & Assembly Instructions

Please contact Customer Service with any questions at:

30700 D Carter Street ∙ Solon, OH 44139 ∙ (P) 440.248.5480 ∙ support@tritonproducts.com

For a full line of products visit www.tritonproducts.com 1

Read all instructions completely before installing. Should you have any questions about your

installation, please call Customer Service at 440-248-5480

Tools needed for this installation (not supplied with kit): Drill, Phillips Screwdriver, Tape Measure, Level

Parts Listing

Part Number Quantity Description

990 | 990-S 2 Polypropylene Pegboard 18” x 22” x 1/8” thick

24 Assortment DuraHook Locking Pegboard Hooks

32 Lock Screws for hooks (packaged separately)

2 Hanging Plastic Bins

2 BinClips for Hanging Plastic Bins

18 #12-2” long wood screws

18 #12 plastic wall anchors

18 Metal wall mounts/spacers

1. Wall Mounting Instructions: Polypropylene pegboards can be mounted to walls in separate

locations, side by side horizontally or above one another vertically.

A. Determine the location or locations where you want to mount your new storage system.

B. Determine if you want to mount boards (a) side by side horizontally, (b) above or below one

another, or (c) in a different location.

C. Using one sheet of the Polypropylene Pegboard (DuraBoard®) determine the location and height

you wish to mount your DuraHook storage system.

D. (Using diagram 1-1) Hold one sheet of pegboard flat against the wall surface, use level to make

sure board is level and square.

E. (Using diagram 1-1) While still holding pegboard flat against wall level and using a pencil, make a

circular trace inside of all (9) hole locations using diagram 1-1. (If planning to mount boards in

totally separate locations go to step (H)

F. If you’re planning to mount the second pegboard directly to the side or above or below the first:

Hold the first pegboard flat against the wall while making sure all 9 traced holes are still aligned

with appropriate holes in pegboard. Using a pencil, trace the outer edge of the board you’re

planning to mount the second board against.

G. If mounting side by side or above or below one another: use the second board in your kit, align

outer edge with pencil mark created in step (F). Do not cover up pencil mark with board. Mark

hole locations as listed in step (E).

990 | 990-S DuraHook Locking Pegboard System

PAGE 1
Installation & Assembly Instructions 990 | 990-S DuraHook Locking Pegboard System Read all instructions completely before installing.
PAGE 2
Installation & Assembly Instructions H. Using an electric drill with 5/16" drill bit, drill hole locations marked in step (E). Should any hole location fall in line with a wood wall stud, it will not be necessary to pre-drill. I. Gently insert plastic wall anchors into holes pre-drilled in step (H.) (You will not need to install plastic wall anchors where a wall stud is located or when installing on solid wood surfaces. Wall anchors will be required for all concrete walls. J.
PAGE 3
Installation & Assembly Instructions Diagram 1-1 Diagram 1-3 Diagram 1-2 LIMITED LIFETIME WARRANTY: Triton Global Products are backed by a Limited Lifetime Warranty to the original owner that our products are free from defects in material and workmanship.