User Manual

ESC Programing Card Manual

SPECIFICATIONS:

1. Size: 55.0mm*42.5mm*3.5mm（L*W*H）

2. Weight: 6.5g

HOW TO USE:

1. Connect the ESC to the motor.

2. Posion the blue jumpers to the sengs desired for each parameter.

3. Plug the ESC lead into ‘ESC’ terminal located on the top of the card as shown. Ensure the lead

it connected the correct way around (ground, power, signal)

4. Connect the ESC to the baery pack.

For the ESC without a built-in BEC (OPTO), you need to connect the extra power (4.8-6.0V) or

UBEC to the connector marked “ - +”.

5. You will hear one short beep once power is connected conﬁrming that your sengs have been

stored. If you hear a long beep (about 10 seconds), the sengs are invalid and have not been

stored. Check you sengs and start over.

6. Disconnect your baery pack and the programming card.

7. Your Duraﬂy ESC is now programmed and ready to use with new sengs.

Connecon Diagram

OPTO / UBECESC

PAGE 1
ESC Programing Card Manual SPECIFICATIONS: 1. Size: 55.0mm*42.5mm*3.5mm L*W*H 2. Weight: 6.5g HOW TO USE: 1. Connect the ESC to the motor. 2. Position the blue jumpers to the settings desired for each parameter. 3. Plug the ESC lead into ‘ESC’ terminal located on the top of the card as shown. Ensure the lead it connected the correct way around (ground, power, signal) 4. Connect the ESC to the battery pack. For the ESC without a built-in BEC (OPTO), you need to connect the extra power (4.8-6.
PAGE 2
Durafly ESC Programing Card Manual DESCRIPTION OF SETTINGS: Battery type: LiPo or NiMh * NiMH – Sets Low Voltage protection threshold for NiCad/NiMH cells. * LiPo – Sets Low voltage protection threshold for LiPo cells and automatically detects the number of cells within the pack. Note: Selecting the NiCad/NiMH option for the battery type, triggers the ESC to automatically set the cutoﬀ threshold to the factory default of 60%.
PAGE 3
Durafly ESC Programing Card Manual Soft Acceleration Start ups: Very Soft / Soft Acceleration/ Start Acceleration * Very Soft – Provides initial slow 1.5 sec ramp-up from start to full rpm intended to protect delicate gears from stripping under instant load. This setting is recommended for either ﬁxed wing models equipped with gearboxes and / or helicopters. * Soft Acceleration- Provides initial slow 1 sec ramp-up from start to full rpm.