Prime Tundra Plug N Fly Instruction Manual

1.For this step you need the wing and the two
plastic wing protectors. If you are using the
bandon wing system then you must use both
protectors. If using the bolt-on system then
you do not have to use them if you do not
want to.
2.If you have elected to use the band-on
method, then use a good quality glue such as
UHU Por to glue the protectors to the wing.
3.Plastic protectors glued into their correct
positions.
4.At this point you can stick the dummy window
to the center of the wing.
5.If using the band-on method then select this
wing retaining dowel set. The long one goes
to the front, and the short one to the rear.
7
6.Slide the carbon rod with the band retainer on
one end through the fuselage. Use a small
drop of CA glue to secure the second plastic
band retainer into place.
Step 4: Wing Assembly.
DURAFLY PRIME TUNDRA 1200MM
PLUG AND FLY VERSION