Prime Tundra Plug N Fly Instruction Manual

3.Next stage is to attach the wing struts to the
fuselage using the two M2x10mm screws and
lock nuts.
4.Ensure that you attach the wing struts so that
the large dished end faces the underneath of
the wing.
5.Also the struts are handed with one marked
with an "L". This strut goes on the left hand
side looking from the rear.
6.Attach the struts using the M2x10mm bolts
using the supplied hex key and a spanner or
thin nosed pliers.
6
7.Ensure that the strut goes on the underneath
of the strut attachment and also the head of
the bolt is underneath with the nut on the top.
8.Above shows the struts in the stowed/ travel
position. Note: You can tighten the M2 nuts
and bolts as the struts will swivel on the
ballink.