Prime Tundra Plug N Fly Instruction Manual

Step 3: Wing Strut Assembly.
5.Using two of the 2.3x8mm self tapping
screws, secure the two stabilizer halves to
the rear of the fuselage.
6.Using the third 2.3x8mm self tapping screw,
secure the joint between the two elevator
halves.
7.Clip the ballink on the pushrod onto the ball
that is attached to the control horn. If the
elevator requires adjustment to ensure it is
neutral, this will be covered later in the set-up
part of the manual.
8.Firmly push the tailwheel assembly into place
in the bottom of the rudder. Secure with two
2.3x10mm self tapping screws.
1.Identify the parts for the wing strut travel
retainers. Two off retainers and four off
2.6x6mm self tapping screws.
2.Mount the wing strut retainers using the four
2.6x6mm self tapping screws.
5
DURAFLY PRIME TUNDRA 1200MM
PLUG AND FLY VERSION