Prime Tundra Plug N Fly Instruction Manual

Step 8: Battery Installation and Setting CG.
1. The recommended center of gravity (CG) for the Prime Tundra should be approximately 55-60mm from the
leading edge of the wing. This should be easily achieved if you use a 1300~1400mAh 3S LiPo battery
weighing between 110~125g. Ensure it is up against the foam ledge in the battery compartment as shown in
the picture below. Once the position of the battery is determine, secure it in place with the supplied hook and
loop tape.
2.This picture shows the battery position, as mentioned above, ensure the battery touches the ledge
at the rear of the battery compartment. With the battery in this position you should easily achieve the
correct CG. Also at this point, fix the Aerostar ESC (Electronic Speed Controller) to the side of the
fuselage with the supplied hook and loop tape.
CG 5 -60mm from leading edge.
CG
5
-60mm
16