Prime Tundra Plug N Fly Instruction Manual

1.Please ensure you fit the propeller the correct

way around. The picture above shows the

front of the propeller, so this of course should

face forwards, in the direction of flight.

2.Remove the prop nut from the motor

shaft,slide the propeller onto the shaft and

replace the nut. Please make sure that the

molded on washer of the nut goes up against

the face of the propeller. Once finger

tightened, use a spanner to tighten the nut,

please do not overtighten otherwise you may

snap the shaft.

Step 7: Fitting the Propeller.

Your Prime Tundra is now ready

for checking the CG and its first flight.

Now you have finished setting up the radio, gyro, and servos, you can install the propeller

onto the motor shaft.

Note: Now the propeller has been fitted, please be extremely careful when switching the model

on, ensure that the transmitter is set correctly before switching on and connecting the battery.

DURAFLY PRIME TUNDRA 1200MM

PLUG AND FLY VERSION