Prime Tundra Plug N Fly Instruction Manual

13
16. You will now need to set the control throws, these should be as follows. The lower figure is with
the D/R (Dual Rates) switched on, and the higher figure with the rates switched off. If you are not
sure how to set the Dual Rates, please consult your transmitter manual. Do these checks with the
gyro in the off position.
Mid flaps should measure around 15mm
from the fully up position.
Full flaps should measure around 30mm
from the fully up position.
Measure the flaps at the inboard end, the end nearest the fuselage.
Elevator
-1 mm
-1 mm
-1 mm
-1 mm
5
- 0mm
1
-2 mm
1
-2 mm
Rudder
Aileron
Note: Measure the elevator throws at the end nearest the rudder.
Measure the rudder throws at the base of the rudder. The ailerons as they are a constant
chord so can be measured either end.
DURAFLY PRIME TUNDRA 1200MM
PLUG AND FLY VERSION