Prime Tundra Plug N Fly Instruction Manual

DURAFLY PRIME TUNDRA 1200MM

READY TO FLY VERSION

11.For the rudder or elevator, use the supplied

hex-key. Slacken the grub screw in the servo

connector, move the control surface to

neutral and re-tighten.

10. Your Prime Tundra now needs to be set up so that all control surfaces are set at neutral. With the

system switched on and the gyro initialized the control surfaces should all be in their neutral position.

Ensure when you do this that the gyro is off, and all the trimmers on your transmitter are also in their

neutral position. If for any reason a control surface is not at neutral, you will need `to do one of the

following.

12.For the flaps or ailerons, gently ease the ball

link off of the ball with a pair of long nosed

pliers. Be careful not to damage or break the

control horn.

13.Adjust the ball link as necessary by turning it

clockwise, or anti-clockwise

14.Just using your fingers, carefully, but firmly

snap the ball link back onto the ball. Use a

finger behind the control horn to support it as

you do this.

Aileron Elevator Rudder