Prime Tundra Plug N Fly Instruction Manual

9
3. Before switching your transmitter on, ensure
that the throttle stick is fully down and throttle
trim is in the middle position as shown on the
T6A. Also, if you have programmed a throttle
disarming switch, ensure it is in the disarm
position, the gyro switch can be in any position.
Now switch the transmitter on, and ensure your
battery indicator is in the green.
4.Now connect your 3S (11.1V) LiPo battery
into the speed controller XT60 connector.
Once the battery has been connected, do not
move the model until the gyro has initialized.
During the initialization process the ESC will
emit a series of beeps then will go silent. The
servo arms will move several times then
return to neutral, the gyro is now calibrated
and ready to use.
6. When the transmitter and receiver have
bound together and the gyro has initialized, the
gyro light will be doing one of the following,
depending on the position of your chosen
auxiliary switch. Position 1 should be with the
switch fully up and this will give a slow flashing
light, this means the gyro is off. With the switch
in the middle, position 2, the light will flash
quickly, meaning the gyro is on. With the switch
fully down, position 3, the light will stay on,
meaning the gyro is in training mode. You may
need to adjust your transmitters servo reversing,
end points, and sub trims to obtain the correct
light sequences on the chosen auxiliary channel.
Once again, you will need to consult your Tx
manual on how to make these adjustments.
5. If your transmitter and receiver bind together
successfully your receiver should show an
indication via an LED that it has safely bound.
The the elevator and rudder servos should
operate normally when you move the sticks on
the transmitter. Now flick the motor arming
switch to armed, or gently open the throttle and
check that the motor runs ok. This activates the
gyro, the gyro will not operate unless the motor
has been armed, or given a short blip of throttle.
Once initially armed it can be disarmed, or
throttle closed, and the gyro will carry on
working.
DURAFLY PRIME TUNDRA 1200MM
PLUG AND FLY VERSION