Excalibur V2 PNF Building and Set-Up Manual

Note:

- The propeller should be balanced out of the box, however it is

recommended a final balance check be carried out before

attaching it to the model. A well balanced prop will greatly increase

all round performance and efficiency of the model in flight.

8.The final stage of assembly is to install your

choice of 4-6ch receiver, the smaller the

better. With all servo leads connected, the

receiver can be inserted under the wing

leading edge and secured as desired. Your

1800-2200mah 4S lipo is installed as shown

below. This is also the best location to

achieve the correct CG.

Congratulations,

Basic assembly of your Excalibur V2 is now complete.

Please perform a final check on all screws, bolts and components,

ensuring all are secureand firmly in place.

6. Set the aileron servos to neutral and ensure the arms are vertical as shown. Connect the

aileron pushrods to the servo arm using the supplied quick-keepers. Adjust the ball link if

necessary by turning clockwise, or anti-clockwise, then snap the ball link onto the ball.

7. Fit each prop blade to the center-hub using the hex-

screws supplied, do not over-tighten, they should be free

enough to fold. Assemble the motor adapter, spinner

backplate, and center-hub onto the motor shaft. Fit the

washer and nut, and tighten the assembly so that it is firmly

locked onto the shaft. Attach the spinner using the supplied

screw.