Excalibur V2 PNF Building and Set-Up Manual

FPV CANOPY:
The ‘FPV canopy hatch’ is a free to download 3D file
of the canopy from the files tab of the listing for those
that with to 3D print their own canopy and FPV the
Excalibur V2.
ASSEMBLY
(
PNF
)
:
Note:
- For max strength and security, UHU glue can be used in addition to supplied screws when installing the tail.
- When connecting ball links, the side with the ring molded on, is the side pressed onto the ball.
- Use of heat shrink or sticky tape is recommended to keep the extension/servo lead connections
secure.
FPV canopy 3D file for printing. Download for free here.
3
B.
2.3x6mm
A.
1.Out of the box your Excalibur V2 comes with reinforced foam hinges. However before assembly can
begin, each hinge line must be flexed back and forth 5-6 times to reduce tension and load on the servo.
Do this for all control surfaces before continuing.
2
.Test and center each tail servo then carefully install each tail half into the the housing at the rear of the
fuselage. Connect the servos to the extension leads and ensure they are pushed forward into the
fuselage when fitting the tail, this is to achieve the perfect fit as shown (A). With the tail now correctly in
place, add the top tail mounting plate and secure using the supplied 2.3x6mm screws (B). Turn the tail
over and repeat this process (C). Finally locate and install the tail servo horns and control rods (D). Do
this for all control surfaces before continuing.