tomahawk_manual-180411

P.02
1. Out of the box your Tomahawk comes with reinforced foam hinges. However before assembly
can begin, each hinge line must be flexed back and forth 5-6 times to reduce tension and load on
the servo. Do this for all control surfaces before continuing.
2. With the elevon control horns at 90 degrees to the wing surface or neutral insert the Elevon into
the top hole of the control horn z-bend then using ball link pliers to connect the control horns. Use
CA or contact adhesive to attach the upper vertical fin.
Your Durafly Tomhawk has 4 different coloured stickers to individualise your own model,
please apply the stickers before you assemble the model.
NOTE:
ASSEMBLY :
B