Instruction Manual
"FPV flying is the new way of looking at the world. The Durafly Tomahawk is the best way to get into mini racing FPV flying wings. This wing is only 670mm so it can be easily fitted in your car for an after work flight. The wing is designed for stable flying and also allows for all the extreme maneuvers needed when racing." CONTENT : 4 6 3 5 2 1 7 1. Main wing with preinstalled motor, ESC and servos 2. Upper vertical fins 3. Lower composite vertical fins 4. Optional Action camera battery hatch 5.
NOTE: Your Durafly Tomhawk has 4 different coloured stickers to individualise your own model, please apply the stickers before you assemble the model. ASSEMBLY : 1. Out of the box your Tomahawk comes with reinforced foam hinges. However before assembly can begin, each hinge line must be flexed back and forth 5-6 times to reduce tension and load on the servo. Do this for all control surfaces before continuing. 2.
3. Attach the bottom vertical find with CA foamsafe glue. NOTE: It is recommended that you balance the prop and spinner before installing for optimum performance and effciency. SETTING UP YOUR MODEL: 1. Before you install your propeller and with your receiver installed and all servos plugged into their corresponding channels, connect the flight battery to the ESC to power up the electronics. With the model now armed, ensure all servos are centered and all control surfaces are level.
NOTE: For safety reasons, it is advised that this is done with the prop removed from the model. 2. Check all control surfaces are moving in the correct direction with the applicable stick input (see below) P.
3. The Tomahawk handles very well in flight and that’s not down to good design alone, but a good pre-flight set-up too. Before you fly you Tomahawk please follow the recommended settings below for optimum handling and performance. Control throws: Elevon CoG or centre of gravity is 175-180mm from the nose of the Durafly Tomahawk P.
P.
