Installation Guide

CARE AND MAINTENANCE

CLEARANCE TO COMBUSTIBLES

Keep electrical cords, drapery, furniture and other combustibles at least 3 ft (0.9 m) from the front of the

heater and away from the sides.

CLEANING TRIM

Clean the metal trim using a soft cloth, slightly dampened with a citrus oil-based product and buff with

a soft, clean cloth. DO NOT use brass polish or household cleaners as these products will damage the

metal trim. Purchase citrus oil-based products at a hardware store.

REPLACING THE LIGHT BULBS

This electric stove uses two clear 120-V, 40-watt, E12 socket base light bulbs (candelabra base, B bulb).

Access the 40-watt bulbs through the rear access panel (see illustration below). For convenience,

replace all bulbs at the same time if one goes out.

1. Turn the main power switch off, and then unplug the power cord from the wall outlet.

2. If replace has been operating, let the unit cool at least 2 hours.

3. Loosen the screws holding the stove back panel to the main body of stove (see Fig 6).

4. Pinch the spring clip to loosen the spindle, and pull the rubber gromet out of the spinner motor shaft.

(see Fig.7).

5. Pull the spinner out of the bracket.(see Fig 7).

6. Remove light bulbs and replace with two clear 120-V, 40 Watt E12 Socket base light bulbs (Fig. 8).

7. Place rear access panel back into position and tighten screws (do not over-tighten).

1. Loosen Phillips

head screws

2. Remove back

panel to access

light bulbs

3. Replace all

light bulbs

Spinner

Fig. 7

Fig. 6

Fig. 8

Light bulb holding spring

Pull

Ember bed

light bulb

WARNING:Do not exceed 40 watts per bulb. Use of higher rated bulbs may result

in a re, causing property damage or personal injury.

Pinch this spring clip

to loosen and pull

the rubber out of the

motor shaft.

Pull