Installation Guide

OPERATING INSTRUCTIONS
TO ACCESS CONTROL PANEL - Open the door to access the control panel.
- POWER
The Power switch supplies power to all of the functions of the replace and will illuminate the ame effect.
This switch must be in the ON position for any of the functions to work.
NOTE: Holding the POWER button on the control panel for 10 seconds will disable the heater function.
Re-activate the heater function by holding this button for 10 seconds again. The controls will beep several
times when this function is activated.
- HEAT
Your replace consists of a fan-forced wire element type heater. The HEATER switch turns the heater ON
and OFF. This switch must be in ON position for the heater function to work.
- TEMPERATURE
The Temperature control knob regulates the temperature level of the heater. The further the knob is
rotated clockwise, the higher the set point temperature. Turning the knob counter-clockwise will lower the
set point temperature. Use this function to help regulate the ambient temperature level.
( + - ) - BRIGHTNESS
Use + - to increase or decrease the ame brightness levels.
WARNING: Turn the power off when servicing this appliance. First turn the main power switch
to the “OFF” position. Then remove the electrical plug from the wall outlet.
Fig. 5
5
NOTE: Please operate remote
transmitter at a slow measured pace.
Press the remote control buttons with
an even motion and gentle pressure.
Repeatedly pressing buttons in rapid
succession may cause the transmitter
to malfunction.