User's Manual

-9-
IV. MINIMUM FIREBOX DIMENSIONS
WARNING: Maintain or exceed the minimum clearances.
V. CLEARANCES (Vent-free operation only)
WARNING: Maintain or exceed the minimum clearances.
VI. INSTALLING DAMPER STOP (Vented operation)
For vented operation of this appliance, a damper stop must be installed in the replace to prevent
full closure of the damper blade. The damper stop must be adjusted to provide a minimum ue
opening of 29 square inches. You can obtain a damper stop at your local hearth products dealer
or hardware store.
WARNING: The fireplace and log set function as a system. If the fireplace is spilling
combustion gases into the room (check draft with a match, candle or smoke stick), reposition
the damper clamp to open the damper wider, until a positive draft (i.e. all combustion
emissions go up the chimney) is obtained.
VII. INSTALLATION
1. Carefully remove the contents of the carton. You should nd:
• The burner / base (Figure 1)
• Four (4) ceramic ber articial logs (Figure 3).
• Two (2) appliance base screws inside a small bag.
• One AA battery.
If components are missing, contact Duraame Consumer Aairs.
2. Remove all these components from their packaging. When handling the logs, take care not
to damage them. Keep packing materials away from children, as they could be a choking or
suocation hazard.
Figure 2
Minimum Dimensions of Firebox
Firebox Back
Firebox
Side
19”
18”
31”
15”