Use and Care Guide

MP#YC23RM20201REV.0
23
EXPLODED VIEW
CARE AND MAINTENANCE
Part Part Name
1 Flame Generator Drive Motor
2 Emberbed Circuit Board
3 Blue Flame Circuit Board
4 Flame Circuit Board
5 Flame Generator/ Spinner
6 Main Circuit Board
7 Heater/Blower Assembly
8 Control Panel Circuit Board
9 Control Panel Buttons
10 Emberbed with Log
11 Log Circuit Board
12 Remote Control
13  ermostat Sensor
•  e motors used on the fan and the  ame generator assembly are pre-lubricated for extended bearing life and require no
further lubrication. However, we recommend periodic cleaning/vacuuming of the fan/heater.
• Clean the trim using a so cloth, slightly dampened with citrus oil based product and bu with a clean so cloth.
DO NOT use brass polish or household cleaners as these products will damage the metal trim. Citrus oil based products
can be obtained at supermarkets or hardware stores.
• Make sure the unit is turned OFF and unplugged before cleaning the heater or  replace.