Operating Guide
www.tsicustomerservice.comA392
6
is product is equipped with a safer Plug; an advanced safety
device that helps detect electrical res caused from faulty outlets.
Overloading of outlet, adapters and surge protectors may cause
overheating, damage, and increase risk of res. Safer Plug
continuously monitors the temperature in the plug and outlet and
will turn o the heater to prevent unsafe outlet overheating.
If the Safer Plug cuts the power due to unsafe conditions it will
show an “ ”message on the screen. If this occurs the Safer Plug
has prevented a potentially unsafe condition.
To reset the device if this occurs, rst allow the plug to cool down.
Once the plug has cooled down, unplug the device and wait 5
seconds, then plug back in and continue to use normally.
If the Safer Plug continues to activate your outlet may be faulty.
Check your heater cord and plug connections. Faulty wall outlet
connections or loose plugs can cause the outlet or plug to overheat.
Be sure the plug ts tight in the outlet. Heaters draw more current
than small appliances, overheating of the outlet may occur even if
it has not occurred with the use of other appliances. During use
check frequently to determine if your plug outlet or faceplate is
HOT! If so, discontinue use of the heater and have a qualied
electrician check and/or replace the faulty outlet(s).
is product is equipped with a Safer Sensor; an advanced safety
device that helps prevent heaters from being accidently covered or
blocked causing a potentially unsafe condition.
e SAFER SENSOR detects if an object is too close to the front
of the heater potentially obstructing the air outlet. If blocked, the
SAFER SENSOR icon on the control panel will ash, the heater
will beep continuously, and then shut o. Once the object has been
moved, the icon will stop ashing, the beeping will cease, and the
heater will turn back on.
To disable the Proximity Sensor safety function press and hold
the ECO MODE button for 10 seconds. Once disabled the SAFER
SENSOR icon will remain lit indicating it is disabled. Repeat this
step to re-enable the function.
SAFER PLUG
SAFER SENSOR
OPERATION INSTRUCTIONS
FUNCTION ICON DESCRIPTION