Instructions / Assembly

Tool List (not included): Hepa filtered vacuum, safety glasses, dust mask, 6-foot or laser level, tape measure, pencil, framer’s or speed
square, utility knife with blades, 100 lb. three-section roller, or a wall or laminating three-section roller with extendable handle (~
9-inch wide), and knee pads. Optional; guillotine style cutter.
Layout: It is recommended to remove the wall-base or baseboard and to undercut the door trims (to slide the flooring under). The
layout should be balanced with equal sizes on both sides. Measure the width of the area, calculate and mark your center line (pencil
and straight edge). This will be used as your starting line, however, if the last row (at the wall) is less than half the width of a plank, then
move your line over by half the width of a plank.
It is recommended to use a random pattern with ≥ 6-inches end-seam separation from the previous row. Measure, plan, and mark
your starting point. Clean the entire area to be installed (Hepa filtered vacuum).
Mix planks from several boxes to ensure a random appearance. During the installation, inspect for visible defects, including damage,
gloss, color, or shade variations. If you have any concerns, do not install them as doing so assumes acceptance and full responsibility
for the damaged or defective material. If required, immediately contact the technical department at [e-mail]
for assistance.
July 2019