Full Product Manual

polishedpro | 5.2mm Rigid Core
DuraDecor | P: (855) 700 - 5666 | [e-mail] | duradecor.com | revised on 06.23.23 | Page 3
Technical Data Sheet
General Specifications
Overall Product Thickness:
Underlayment Thickness:
Wear Layer Thickness:
Product Type:
Product Dimensions:
Finish:
Residential Warranty:
Commercial Warranty:
Carton Quantity - Plank:
Carton Weight:
Technical Specifications
ASTM F3261 - Rigid Core Specication:
ISO 24337 - Size & Squareness:
ASTM F387 - Thickness of Flooring w/ Foam Layer:
ASTM F410 - Wear Layer Thickness:
ISO 24337 - Flatness:
ISO 24337 - Joint Opening:
ISO 24337 - Joint Ledging:
ASTM F1914 - Residual Indentation:
ASTM F1914 - Surface Integrity:
ISO 23999 - Dimensional Stability:
ISO 23999 - Curl:
ASTM F925 - Chemical Resistance:
ASTM F1514 - Resistance to Heat:
ASTM F1515 - Resistance to Light:
ASTM F970 - Static Load:
ASTM E648 (NFPA 253) - Critical Radiant Flux:
ASTM E662 (NFPA 258) - Smoke Density:
ASTM D2047 / UL 410 - Slip Resistance:
ASTM E492 / E989 - Impact Insulation Class:
ASTM E90 / E413 - Sound Transmission Class:
ASTM E2179 - Delta Impact Insulation Class:
5.2 mm
1.0mm XPO Foam
20 mils (0.5 mm)
Rigid Core Floating Floor
5.75" x 47.75"
Scratch-Resistant Polyurethane
Lifetime
10 Years
10 Pieces (19.07 sq. ft.)
33 lbs.
Class I, Type B, Grade 1, Backing Class B
Passes, ± 1.5 mm size, ± 0.25 mm squareness
Passes, ± 0.2 mm
Passes, ≥ 0.5 mm
Passes, ± 0.2 mm width, < 0.2% length
Passes, ≤ 0.2 mm
Passes, ≤ 0.15 mm
Passes, ≤ 0.18 mm
Passes, no puncture
Passes, ≤ 0.2% / lin. ft.
Passes, ≤ 2 mm
Passes ASTM F3621 requirements
Passes, < ∆E 8
Passes, < ∆E 8
Passes, ≤ 0.13 mm indent, 250 lbs.
Class 1, > 0.45 W/cm2
Passes, < 450
> 0.5 SCOF (no ramps)
IIC 57 (6 in. Concrete)
STC 50 (6 in. Concrete)
∆IIC 25 (6 in. Concrete)
Disclaimer: These test results were independently tested, using material from standard production, in accordance with
product-specic standard test methods. Physical and performance testing may vary, within tolerances, depending on
the testing apparatus and/or production lot used. Be sure to use the most recently published versions of all reference
documents, specications and test methods. To purchase the most recent version of the above mentioned ASTM and ISO
standards, please visit www.astm.org. or www.iso.org, respectively. Test reports are available upon request.