classychic | Rigid Core Product Guide
Table of Contents Technical Data Sheet 3 General Information 4 Recommended Tool List 5 Installation Instructions 6 Installation Images 9 Maintenance Instructions 11 Product Warranty 12
classychic | Rigid Core Technical Data Sheet General Specifications Overall Product Thickness: Underlayment Thickness: Wear Layer Thickness: Product Type: Product Dimensions - Plank: Product Dimensions - Tile: Finish: Residential Warranty: Commercial Warranty: Carton Quantity - Plank: Carton Quantity - Tile: Carton Weight - Plank: Carton Weight - Tile: 5.0 mm 1.0mm IXPE Foam 12 mils (0.3 mm) Rigid Core Floating Floor 5.75" x 47.75" 11.75" x 23.
classychic | Rigid Core General Information Limitations This flooring has a Solid Polymeric Core (SPC) and is designed to be installed indoors only as a “floating floor” for residential applications. The optimal operating temperature is between 40°F to 90°F (4°C to 32°C). Avoid prolonged exposure to direct sunlight or other heat sources where temperatures will exceed 90°F (32°C), as damage may occur. This product is not suitable for heavy rolling loads.
classychic | Rigid Core Recommended Tool List • Knee Pads • Safety Glasses • Cut-Resistant Safety Gloves • Dust Mask • HEPA-Filtered Vacuum • Oscillating Multi-Tool or Hand Saw (for door jambs) • Jigsaw with Carbide Blades(for complicated cuts) • 2 lb. (~32 oz.
classychic | Rigid Core Installation Instructions 1. Substrate Preparation Flatness Check all substrates for flatness prior to installation. The maximum acceptable tolerance is < 1/8-in. gap (2 x US quarters) over 6-ft. and ≤ 1/16-in. gap (1 x US quarter) over 1-ft. Make any necessary adjustments to the substrate before installation. Dormant cracks, saw cut joints and grout lines < 1/8-in.
classychic | Rigid Core Installation Instructions such as water, pet urine and spills. While ClassyChic Rigid Core Flooring is a waterproof product, water-sensitive subfloors may require additional protection to prevent water exposure. When installing floor covering in wet areas, ensure that bathmats or similar are used where appropriate to decrease the amount of water that can collect on the surface. Any and all spills should be cleaned up immediately after discovering them and within 8 hours.
classychic | Rigid Core Installation Instructions expansion gap. First Row (Slide) At the left corner of the starting wall, position the first tile or plank flush with the walls. Use the side and end without the extended locking mechanism against the walls. Place wedge spacers between the floor covering and wall to maintain the required expansion gap around the entire perimeter (see figure 6).
classychic | Rigid Core Installation Images Figure 1: Preparation - Undercut Doorjambs Figure 4: Cutting - Snap plank downward Figure 2: Layout - Stagger seams Figure 5: Installation - Mark the starting line Figure 3: Cutting - Mark, score and cut Figure 6: First Row - Place wedge spacers DuraDecor | P: (855) 700 - 5666 | customercare@duradecor.com | duradecor.com | revised on 06.23.
classychic | Rigid Core Installation Images Figure 7: First Row - Slide planks together Figure 10: End Joints - Lock piece into place Figure 8: Side Joints - Install piece at 25° angle Figure 9: Side Joints - Align joint with previous DuraDecor | P: (855) 700 - 5666 | customercare@duradecor.com | duradecor.com | revised on 06.23.
classychic | Rigid Core Maintenance Instructions 1. Precautions Remove all metal objects before conducting maintenance and prohibit foot traffic until the floor is dry. Do not use dust mops treated with oils or silicones, acetone, strong alkaline cleaning agents, multi-surface cleaners, vinegar/ ammonia/ citrus oil solutions, scouring powder, strong solvents, or abrasive cleaning pads, as these can damage the flooring.
classychic | Rigid Core Product Warranty 1. General Terms 2. Warranty Terms & Provisions DuraDecor (“Manufacturer”) warrants that, when used properly and under normal operating conditions, the flooring products described in the Manufacturer’s catalog as ClassyChic Rigid Core Flooring (“Product”), a 5.0mm thick rigid polymeric core floating floor covering that includes a 0.
classychic | Rigid Core Product Warranty Residential Labor Coverage: Light Commercial Labor Coverage: ≤ 1-year: 100% ≤ 1-year: 100% ≤ 5-years: 60% ≤ 3-years: 50% ≤ 10-years: 40% ≤ 5-years: 0% ≤ 20-years: 20% > 20-years: 0% 2.5. Waterproof Warranty: The Product will not be materially impaired when exposed to wet or damp cleaning, surface spills and/or tracked in water for the length of the Wear Warranty. This does not include water emergencies. 2.6.
classychic | Rigid Core Product Warranty While independent test results are available, that does not purport to address any safety concerns of slip resistance, the accuracy of all test methods, safety thresholds, or the measuring apparatus’ (tribometers). This includes factors outside of the reasonable control of the Manufacturer, such as Product maintenance. No warranty for any slip resistance properties can be provided.
