Owner`s manual

Fill the tank with COOL
tap water. Distilled water
is not necessary as the
water is filtered by the
Natural Cool Moisture
filter. DO NOT USE HOT
WATER.
After filling the tank,
remove the Fill Hose from
the faucet and let any
remaining water drip into
the tank before moving
the other end of the hose.
Replace the fill cap by
turning it clockwise. DO
NOT OVER TIGHTEN.
NOTE: WHEN CARRYING
THE FILLED WATER TANK,
PLEASE USE THE HANDLE
AND PLACE YOUR OTHER
HAND UNDER THE TANK
FOR ADDITIONAL
SUPPORT.
Turn the water tank
right-side up and reposi-
tion in the humidifier.
Some water will empty
into the reservoir base
when the filled water tank
is properly positioned.
NOTE: THE RESERVOIR
BASE HOLDS MORE
WATER THAN THE WATER
TANK; IT MAY, THERE-
FORE, BE NECESSARY TO
FILL THE TANK MORE
THAN ONCE TO FILL THE
HUMIDIFIER COMPLETELY.
Once the filled tank
has been positioned, do
not attempt to move the
humidifier. If it has to be
moved, unplug the humidi-
fier and remove the water
tank first.
Reposition the Power
Unit on the left above the
Natural Cool Moisture
filter.
Replace the Top Grill
on the right.
NOTE: DO NOT POUR
WATER INTO THE GRILL
THROUGH THE TOP OF
THE POWER UNIT. DOING
SO MAY DAMAGE THE
HUMIDIFIER OR CAUSE
PERSONAL INJURY.
With the power switch
in the OFF position, plug
the filled humidifier into a
polarized 120V outlet.
DO NOT FORCE THE
POLARIZED PLUG INTO
THE OUTLET;
it will only fit
one way.
CAUTION: DO NOT PLUG
IN THE HUMIDIFIER WITH
WET HANDS AS AN ELEC-
TRIC SHOCK COULD
OCCUR.
Slide the Humidity Level
control to HIGH.
Turn on the humidifier;
the Power Switch will
illuminate.
Set the Moisture Output
Control to the desired
speed:
SUPER for fast
humidifying.
HIGH for normal.
QUIET for quieter
operation.
NOTE: IF THE HUMIDIFIER
FAN WILL NOT START
OR RESTART WHEN
YOU SELECT A SPEED, THE
HUMIDISTAT MAY BE SET
TOO LOW. MOVING THE
HUMIDITY LEVEL (HUMIDI-
STAT) CONTROL TO A
HIGHER SETTING SHOULD
RESTART THE FAN.
The length of time of
your humidifier runs will
vary depending on the
quality of construction and
insulation of your room or
house, as well as the fan
speed.
When a comfortable
humidity level is reached,
lower the Humidistat set-
ting slowly until the fan
stops. The DESIRED
HUMIDITY light will illumi-
nate, indicating that the
desired humidity setting
has been reached. The
Humidistat will automati-
cally restart the fan each
time the humidity level
falls below this setting.
OPERATION