Owner`s manual

SET UP

NOTE: We recommend that the humidifier be disinfected prior to first use.

Please see CLEANING instructions.

• Select a firm, level, flat location - at least six inches (15 cm) from any wall

for proper air flow (Fig. 1). Place the humidifier on a water-resistant sur-

face, as water can damage furniture and some flooring.

The manufacturer will not accept responsibility for property damage caused

by water spillage.

• Remove the water tank by grasping handle and

pulling straight up. Set aside (Fig. 1).

• Remove the Natural Cool Moisture™ filter from

the base before filling the unit with water (Fig.

2). Soak filter in a sink full of cool water to help

reduce mineral build up and place back in the

humidifier while wet. DO NOT SQUEEZE OR

WRING OUT THE NATURAL COOL MOIS-

TURE™ FILTER. To help extend the life of your fil-

ter repeat this step each time you fill your

humidifier.

• Turn the Water Tank upside down so that the Fill

Cap is facing up; unscrew the Fill Cap by turn-

ing it counter-clockwise and set aside.

•

Fill the Water Tank with COOL tap water (Fig. 3).

Distilled water is not necessary as the water is fil-

tered by the Natural Cool Moisture™ filter.

NOT USE HOT WATER.

Doing so may damage the

humidifier.

• Replace the fill cap by turning it clockwise .

DO NOT OVER TIGHTEN. Turn the Water Tank

right-side up.

NOTE: WHEN CARRYING THE FILLED WATER TANK

PLEASE USE THE HANDLE AND PLACE YOUR

OTHER HAND UNDER THE TANK FOR ADDITION-

AL SUPPORT.

FILLING

HANDLE

Fig. 1

Fig. 2

Fig. 3