Full Product Manual

Solar LED Floodlight
Model: SS8C-P5-BKT-1
Solar panel
Solar panel
Before First Use
Choose the right locaon
Select a locaon with full and direct sunlight. Do not install in shady areas as these
areas will not allow the baery to fully charge and will reduce nighme working hours.
Be sure that the selected locaon is not too close to other nighme light sources (e.g.
streetlights, porch lights, or other solar lights) as they may keep the light from turning
on automacally at night.
Charging the baery
Make sure switch is in the “6H” or “10H” posion. Baery cannot be charged in
the “OFF” posion. For opmum performance, it is best to install the xture in
full and direct sunlight and charge for at least 10-12 hours a day. Allow the xture
to run at least 8-12 complete charging and discharging cycles for the baery to
reach its maximum capacity.
Assembly and Installaon Instrucons
Step 1 (Fig. 1)
Before assembly, choose preferred working mode of light using the switch located
underneath the solar panel.
Mode Light output Runme
6H 60 lumens for 6 hours 6 hours
Off Powered o
10H 48 lumens for the rst 5 hours, 24 lumens for remaining 5 hours 10 hours
Step 2 (Fig. 2)
Twist knob (C) to secure the spotlight (A) and the panel. Aach the connector (B) to the spotlight (A).
Push the light assembly onto the ground spike, then into the ground. Cauon: DO NOT use a hammer. For
ground with hard soil, to prevent breaking the ground spike, use trowel to loosen the soil rst.
Replacing the baery (Fig. 3)
Push the release tab and open solar panel. Replace old baeries with (2) new 850 mAh 3.2V 18500
LiFePO4 solar rechargeable baeries. Close compartment. Note: a minimum capacity of 850 mAh is required. CAUTION: CONTAINS LITHIUM
PHOSPHATE BATTERIES. BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY. DO NOT INGEST. Do not dispose baery in re. Baery
may explode or leak. Ensure the baery is installed correct with regard to polarity (+ and -).
Troubleshoong
condions:
1. The baery is not fully charged. Make sure the xture is located in an area where it can receive the maximum amount of full and direct sunlight
for 10–12 hours a day. If the xture does not receive enough sunlight during any given day (e.g. due to cloudy or overcast weather condions),
it will be recharged on the next sunny day and resume normal operaon. Keeping the solar panel clean is equally important to ensure the
maximum charging performance.
2. The xture is installed too close to other light sources (e.g. streetlights, porch lights, other solar lights, etc.) which may keep the light from turning
on automacally at night. Relocate xture or eliminate other light sources.
3. The baery is reaching the end of its useful life and needs to be replaced.
Winter ps
Keep debris and snow o the solar panel to allow the baery to recharge. If the panel has been covered by snow for a long period of me,
allow the baery to recharge by allowing the panel to receive full sunlight for at least 10-12 hours.
© 2016. This product is distributed by: Jiawei Technology (USA) Ltd. • Hayward, CA 94545
For assistance, call: 1-855-826-7488 • www.DuracellLighng.com
C
A
B
A
D