Operation Manual

E - 13

PLAYING A DISC

This owner’s manual explains the basic instructions of this unit. Some DVD discs are produced

in a manner that allows specific or limited operation during playback. Such as, the unit may not

respond to all operating commands. This is not a defect in the unit. Refer to the instruction notes

of discs.

“ ” may appear on the screen during operation. A “ ” means that the desired operation

is not permitted by the unit or disc.

Basic playback

Playing a Disc

1.Slide the POWER ON/OFF switch on the left side of the unit into “ON” position.

See CUSTOMIZING THE FUNCTION SETTINGS (page 23 to 26) before proceeding to step 2.

2.Slide the OPEN switch to open the disc door.

3.Hold the disc by its sides and carefully place it onto the central support in compartment with the label side facing

up until you hear a “click”.

4.Close the disc door.

It takes a short while for your unit to load the disc. After loading, some discs will automatically start playback.

5.Press the

PLAY button.

DVD

Pausing playback (still mode)

Press the

PAUSE button. To resume normal playback, press the PLAY button.

Stopping playback

Press the STOP button at the location where you want to interrupt playback. To resume playback at the position

where the disc was stopped, press the

PLAY button.

If you press the

STOP button twice, the unit’s memory will be cleared and pressing the PLAY button will reset

the disc to the beginning.

To skip to a different track

• Press the PREV button repeatedly to skip to the start of the current or previous track.

• Press the

NEXT button to skip to the next track.

• For audio CD disc, use the number buttons (remote control only) to jump straight to that track number.