User Guide

17
Touch Pad Control
With the insert sitting up-right, plug the insert into a known good 120vac source. The insert will beep
once. Turn the insert on, the lights will light up and there will be a rolling flame. If the insert doesn’t beep
or the flame and lights turn on instantly or not at all, the touch keypad is defective. Check for ribbon cable
leads coming unplugged from both ends. Check to make sure there is a good connection at the main
control board socket. Refer to Figures 20 and 21.
Figure 20, plug locations defined on main control board
Figure 21, example of ribbon cable coming unplugged from touch pad connector
Thermocouple plug location
Temperature low to high pot plug location
Remote control sensor plug location
Touch keypad plug location