Installation Guide

INSTALLATION OF THE FAUCET
1 New Drinking Faucet Preparation
To install this faucet, you will need to have a hole that is 7/16” or larger. Once you have this size
hole, you can shut off the water supply and get started on the install.
2 Install Drinking Faucet
First, remove the compression nut, sleeve, and locking nut from the faucet’s threated shank.
Next, install chrome flange, rubber washer, metal washer, lock washer, and locking nut onto the
threated shank. Next, turn the gooseneck spout to the desired position, and tighten the locking
nut with a wrench. Lastly, place the compression nut and sleeve on the water supply tube, and
screw onto the threaded shank and tighten with a wrench.
3 Turn on Water Supply and Look for Leaks
Once installation of drinking faucet is complete, turn the water supply on and allow both hot and
cold water to run for at least 30 to 60 seconds each. While water is running, check for leaks
around drinking faucet, and under the sink. Once done you can start enjoying your new Dura
Faucet drinking faucet.
MAINTENANCE AND CLEANING
Cleaning Tips: The finish on your product is designed to retain its beautiful sheen for years. To
maintain the original look of the finish, a little care and caution should be used. We
recommend the use of mild soap and water to clean the product.
THE USE OF ABRASIVE CLEANERS MAY SCRATCH THE FINISH OR CAUSE OTHER
DAMAGE.
RECOMMENDED TOOLS AND MATERIALS
¨ Wrench
BEFORE YOU BEGIN
There are a variety of things to do before installing any new plumbing system into your home or
residence. Before you begin work make sure you:
¨ Shut off the main water supply
¨ Cover your drain to prevent loss of parts
¨ Observed any local plumbing codes
¨ Inspect fixture for damage - Replace as necessary
Dura Faucet reserves the right to make any revisions in the design of products without notice.