Instructions / Assembly

WFRO60X-1

V4.4

STEP

Connect Tubing

Install 1/4" Plastic Tubing for Water Supply Line from Kitchen Faucet Adapter

to System Head Inlet

Determine the length of the 1/4" White Plastic Tubing that will be necessary to connect the RO System Head Inlet (labeled “INLET”)

to the Kitchen Faucet Adapter .Make sure to allow enough Plastic Tubing to prevent kinking in the line. Do not discard the remaining tubing

for it will be used in Step 7.

Cut the 6’-1/4" White Plastic Tubing squarely on both ends with a utility knife, making sure not to crimp the Plastic Tubing during cutting.

Wet one end of the 6’-1/4" White Plastic Tubing with water and push it into the Kitchen Faucet Adapter approximately 5/8" until it stops.

NOTE: Do not bend or crimp 6-1/4" White Plastic Tubing when inserting.

Wet the other end of the 6’-1/4" Clear Plastic Tubing with water and push it into the RO System Head Inlet approximately 5/8" until it stops.

NOTE: The 1/4" Plastic Tubing does not need to be disconnected for general routine maintenance and filter replacement. However,

Plastic Tubing may be easily disconnected if necessary. Simply turn off the water supply to the Filter System and press in the white collar

around the fitting while pulling the Plastic Tubing out with the other hand

Install 3/8" Plastic Tubing for Water Supply Line from

System Head Outlet to RO Faucet

Locate the 3/8" White Plastic Tubing (s(see page 7 Step 2) attached to RO Faucet Body ee page 7 illustration).

Determine the length necessary to connect to the RO System Head Outlet (labeled “FAUCET”).

Cut the tubing squarely with sharp utility or exacto knife.

Wet the end of the 3 /8" White Plastic Tubing with wat

er and push it into the RO System Head Outlet (labeled “FAUCET”)

approximately 5/8”, until it stops.

U A

U F

U A