Instructions / Assembly
WFRO60X-1
6
V4.4
STEP
Install Water Storage Tank
The Tank Ball Valve fitting on the Water Storage Tank may need to be tightened 3-4 turns to get a good seal.
Do not over tighten.
SELECT LOCATION OF REVERSE OSMOSIS FAUCET MOUNTING HOLE
Use an existing sink top hole. This may be blank. This is for the spray hose or soap dispenser
(Must be between 1-3/8” and 1-5/8” in diameter)
Drill a new hole in the sink
Drill a new hole in the countertop next to the sink
TO INSTALL WATER STORAGE TANK:
Apply 2-3 wraps of Plumber’s Tape to the threads on the nipple at the top of the Water Storage Tank
Locate the Tank Connector . Hand tighten onto the Water Storage Tank nipple 3-4 turns, being careful not to
cross thread or over tighten.
Do not connect the tube at this time. This will occur later in the assembly.
Place the Water
Storage Tank next to the Reverse Osmosis Filter System Assembly. The Water Storage Tank can
be placed upright or on its side. Use provided mount stand.
STEP
Install RO Faucet
Y
Before you begin, check pressure in tank. Adjust to between 5 and 7 psi.
ou will need to select the location of the Reverse Osmosis Faucet . You have three options to choose from:
Determine where you are going to install your RO Faucet Body .
Check to ensure the RO Faucet Body will mount flat against the mounting surface.
Visually review the routing of the tubes from the RO System Head to the RO Faucet Body . Check to ensure there is
adequate tube routing space between the RO Faucet Body and RO System Head .
If drilling is needed, drill a 1-3/8" diameter hole in the mounting surface.
IMPORTANT: Drilling holes into countertops and sinks should only be performed by a qualied installer who is certied for drilling such materials.
Drilling of surfaces made of stone or solid surface materials such as granite, marble, Corian™ or other plastic resin products or sinks made of
porcelain and stainless steel may cause permanent, irreparable damage to the sink or countertop surface.
4
5
H E
D E
E E
P
P
P
A P
P A
4
5
1
2
3
4
1
2
3
4
D
E
P
A
YOU WILL NEED AN ACCURATE DIGITAL AIR PRESSURE GAUGE