Instructions / Assembly

QuickTwist

™

Filter Replacement

Turn off the cold water shut-off valve to the RO Filter System Assembly.

Turn each QuickTwist

™

Filter from right to left until it releases. Gently pull down on each used QuickTwist

™

Filter

to remove it from the RO System Head . Discard the used QuickTwist

™

Filters.

NOTE: Place a pan or bucket under the RO Filter System to catch any water drips.

Hold each new QuickTwist

™

Filter with the label facing to the left slightly. The two nozzles on top of each QuickTwist

™

Filter

should be toward the back of the QuickTwist

™

Filter. If holding properly, the two extended flanges on top of the QuickTwist

™

Filter

should be out to each side.

NOTE: When viewing the QuickTwist™ RO System from the front, the and are both WFQTC30001 filters. These filters must be

positioned on the either side of the center position while the is the WFRO1000X or Membrane and must be positioned in the

center position .

Lift each QuickTwist

™

Filter straight up into the RO System Head until the two nozzles seat into the ports and the two

extended flanges on top of the QuickTwist

™

Filter are fully engaged into the RO System Head .

Turn each QuickTwist

™

Filter from left to right until it stops.

Turn on the cold water shut-off valve and the RO Faucet and check for any leaks. If there are leaks, refer to the troubleshooting

information on page 15 of the installation instructions.

Pressure Test and purge system per Step 9.

WFRO60X-1

V4.4

B1 B3