Instructions / Assembly

STEP
Install RO System and Drain In Remote Location
INSTALL A REMOTE DRAIN POINT AND AIR GAP (Remote Location)
You can also run the drain tubing to an existing drain in the house. A floor drain, laundry tub, standpipe,
sump, etc. are suitable drain points. This type of drain is preferred over the drain connector. Check your
local codes. Longer lengths of tubing (see parts list in manual) may be needed.
Always be sure to provide an air gap between the end of the hose and the drain point. This will prevent
wat
er from backing up into the system. Air gaps are required code in most areas.
TO INSTALL A REMOTE DRAIN POINT, COMPLETE THE FOLLOWING STEPS:
Remove the 1/4" Red Plastic Tubing from the RO Faucet Body by pulling gently.
Determine if this length is long enough to reach the drain point. If it is, then insert Restrictor in end of
tubing and then insert this end of tubing into drain port on RO Membrane Filter .
If not, replace the 1/4" Red Plastic Tubing with an adequate length of tubing to reach the drain point.
Then insert Restrictor in end of tubing and then insert this end of tubing into drain port on RO
Membrane Filter . Refer to Step 6 in manual on how to disconnect and connect tubing.
Run the tubing to the drain point and secure at the end with a bracket (purchased locally).
Provide a 1-1/2” air
gap between the end of the tube and the drain.
Remove 3/8" White Plastic Tubing from RO Faucet Body and discard.
Faucet will not have 1/4” or 3/8” tubing attached to the airgap barbs in the RO Faucet Body for
remote installation.
WFRO60X-1
10
V4.4
9
9
1
2
3
4
5
6
R P
B2
B2
I
R
I
T P
P