Instructions / Assembly

WFRO60X-1
9
V4.4
STEP
Connect Tubing (Continued)
AIR GAP FROM FAUCET TO RO ASSEMBLY
Locate 1/4" Red Plastic Tubing already attached to the air gap barb on the
RO Faucet Body .
Determine length necessary to connect to the drain outlet on the RO Membrane Filter .
Cut 1/4" Red Plastic Tubing square and to length with sharp utility or exacto knife.
I
NOTE: SYSTEM WILL NOT OPERATE WITHOUT RESTRICTOR.
nsert Restrictor into end of 1/4" Red Plastic Tubing .
Remove black plug fr
om RO Membrane Filter drain port by pushing on white collar while
pulling plug with other hand. Discard plug.
Insert 1/4" Red Plastic Tubing all the way into the fitting on bottom of RO Membrane
Filter approximately 5/8” until it stops.
Pull on the 1/4" Red Plastic Tubing to be sure it is held firmly in the fitting.
CONNECT 3/8” RED TUBE FROM REVERSE OSMOSIS FAUCET TO DRAIN ADAPTER
The other end needs to be attached to the collet on the sink Drain Connector .
Insert all the way into the fitting approximately 1” until it stops.
Pull on the tube to be sure it is held firmly in the fitting.
C
ONNECT TUBING FROM RO SYSTEM HEAD TO WATER STORAGE TANK
Use the remaining 3/8” White Tubing from Step 6 and determine length necessary
to connect the Tank outlet (labeled “TANK”) on RO System Head to the
Water Storage Tank .
Cut 3/8" White Plastic Tubing square with a sharp utility or exacto knife.
Wet the end of tubing and Insert into compression nut of Tank Connector fitting. Which
was connect to tank previously.
Tighten compression nut to secure tubing to Tank Connector .
Insert the other end of 3/8" White Plastic Tubing into the outlet of the RO
System Head (labeled “TANK”) approximatley 5/8” until it stops.
N
OTE: Tubing lengths should allow for the removal of the assembly from the mount screws
for servicing. If tubing lengths are shortened for neater appearance, it may be necessary to
keep the assembly on the mount sc rews for service.
NOTE: Codes in the state of Massac husetts require installation by a licensed plumber and do
not permit the use of saddle valves. If you live in the state of Massac husetts, review plumbing
code 248-CMR of the Commonwealth of Massachusetts before proceeding with the
i
nstallation.
E
8
1 A
2 A
3 A
4 A
5 A
6 A
1 B
2 B
3 B
4 B
5 B
1 C
2 C
3 C
4 C
5 C
6 B
7 A
8
R
P
R
I
R
B2
R
B2
R
B2
Locate the 3/8” Red Plastic Tubing already attached to the RO Faucet Body .
PT
K
Cut 3/8” Red Plastic Tubing as needed to route in as straight of a run as possible,
without loops, dips, low spots, or kinks.
T
Cut the end of the 3/8” Red Plastic Tubing square with a sharp utility or exacto knife.
T
U
A
E
U
U
D
D
A
P
S
T
A
D
F
K
U
R
U
E
B2 B2
I
R R
5 A
6 A
4 A
A
3 C
U
A
4 C
U
D
B2