Instructions / Assembly

WFQT27000 /WFQT27300 Series
7
V4.0
QuickTwist
™
Filter Replacement
1 Turn off the cold water shut-off valve to the Filter System A.
2 Turn each QuickTwist
™
Filter B from right to left until it releases. Gently pull down on each used QuickTwist
™
Filter to remove it from
the System Head. Discard the used QuickTwist
™
Filters.
NOTE: Place a pan or bucket under the Filter System to catch any water drips.
3 Hold each new QuickTwist
™
Filter with the label facing to the left slightly. The two nozzles on top of each QuickTwist
™
Filter
should be toward the back of the QuickTwist
™
Filter. If holding properly, the two extended flanges on top of the QuickTwist
™
Filter
should be out to each side.
NOTE: When viewing the QuickTwist™ System Head from the front, the QuickTwist™ 1st Stage Filter must be positioned on the left
side (inlet side) and the QuickTwist™ 2nd Stage Filter must be positioned on the right side (outlet side).
4 Lift each QuickTwist
™
Filter straight up into the System Head until the two nozzles seat into the ports and the two extended
flanges on top of the QuickTwist
™
Filter are fully engaged into the System Head.
5 Turn each QuickTwist
™
Filter from left to right until it stops.
6 Turn on the cold water shut-off valve and the Faucet for Filtered Water D and check for any leaks. If there are leaks, refer to
the troubleshooting information in Step 7 of the Installation Instructions.
7 Flush water through the Faucet for Filtered Water for approximately 10 minutes to flush out any air from the QuickTwist
™
Filters.
Check for leaks once more before completion.
2
3
4
X
X
WFQT270005
5
X
X
WFQT270005
X
X
WFQT270005
INLET OUTLET
INLET OUTLET
B1 B2
1ST ST
A
GE
F
ILTER
2ND ST
A
GE
F
ILTER
B1 B2
1ST STAGE
FIL
TER
2ND STAGE
FIL
TER
B1 B2
A
A