Manualshelf

Instructions / Assembly

ManualsBrandsDuPont ManualsKitchenUniversal Carbon Block Whole House Cartridge
12345678910
WFPF13003B V4.1I5
STEP 3
Assemble the System and Install Mounting Bracket
1 Dry assemble the complete system (according to the configuration chosen), including all fittings and valves.
2 Measure the overall length (see diagram) of the configured system.
3 Reduce this measurement enough to allow for the amount of engagement (X) to determine how much pipe to remove from the line.
4 When installing the Mounting Bracket E, position it on top of the System Head A, aligning the bracket holes with the holes in the
System Head. Insert the four 3/4” Mounting Screws F through the Mounting Bracket and into the holes of the System Head until tight.
STEP 4
Mark Measurements and Cut the Plumbing Pipe
CAUTION
Please wear safety glasses to protect eyes when cutting.
1 Mark the section of the plumbing pipe that will need to be removed (X) to allow for the configured system (as determined in Step 3).
NOTE: Measure twice, cut once!
2 Using a pipe cutter or hacksaw, cut the marked section from the plumbing pipe.
NOTE: Use a pan or bucket to catch any remaining water in the pipes.
3 Remove any burrs or debris from the cut edges with a file.
X
STEP
4
1
2
3
1
2
3
4
WFPF13003B
4
V4.0
Assemble the System and Install Mounting Bracket
Dry assemble the complete system (according to the configuration chosen), including all fittings and valves.
Measure the overall length (see diagram) of the configured system.
Reduce this measurement enough to allow for the amount of engagement (X) to determine how much pipe to remove from the line.
When installing the Mounting Bracket
E , position it on top of the System Head A , aligning the bracket holes with the holes in
the System Head. Insert the four 3/4" Mounting Screws
F
through the Mounting Bracket and into the holes of the System Head
until tight.
Mark Measurements and Cut the Plumbing Pipe
Mark the section of the plumbing pipe that will need to be removed to allow for the configured system (as determined in Step 3).
NOTE: Measure twice, cut once!
Using a pipe cutter or hacksaw, cut the marked section from the plumbing pipe.
NOTE: Use a pan or bucket to catch any remaining water in the pipes.
Remove any burrs or debris from the cut edges with a file.
Please wear safety glasses to protect
eyes when cutting.
A
SEE CHART
PAGE 3
STEP
3
CAUTION
3
4
2
3
A
E
E
F
A
3
4