Instructions / Assembly

Universal Drinking Water Series
6
V4.2
STEP
1
Mount the Faucet for Filtered Water (Not Included)
NOTE: Most standard sinks come with 1-3/8" or 1-1/2" diameter water sprayer holes that can be used for mounting the Faucet. If the pre-drilled
holes cannot be used or are not in the desired position, a new hole must be drilled using either a 9/16" or 5/8" drill bit to accommodate the
Faucet. The Faucet for Filtered Water base should be positioned securely on a flat surface with adequate space for proper function. Consider
convenience and appearance of the faucet before installation.
IF YOUR SINK DOES NOT HAVE A WATER SPRAYER HOLE, GO TO
1 . IF YOUR SINK DOES HAVE A WATER SPRAYER HOLE, GO TO 4 .
1 In order to prevent parts and materials from falling down the drain, line the sink with newspaper or a towel.
2 Apply masking tape to the area to be drilled in order to prevent scratching the sink surface or countertop if the drill bit slips
during operation.
3 Using a center punch, mark the drill hole. Use the 1/4" drill bit to make a pilot hole. Then use the 9/16" or 5/8" drill bit to drill the final
hole. Drill completely through the sink or countertop and smooth the rough edges with a file.
4 Mount the faucet for filtered water according to the installation instructions that came with the faucet you purchased.
STEP
2
Install the Kitchen Faucet Adapter (Not Included)
NOTE: Our DuPont™ WFFT100 Series Faucets for Filtered Water come with a Kitchen Faucet Adapter.
1 Locate the cold water shut-off valve underneath the sink. Turn off the cold water supply to the kitchen faucet.
NOTE: If uncertain about which line supplies the cold water, turn on the hot water to the faucet. Allow the water to heat up and carefully
feel the pipes under the sink. The pipe that remains cool to the touch is the cold water supply.
2 Turn on the cold water on the kitchen sink to release pressure and allow water to completely drain from the line.
continued to next page
X
X
RIGID TUBING INSTALLATION
5
3
2
4
6
KITCHEN FAUCET
KITCHEN FAUCET
FAUCET FOR
FILTERED WATER
Installing Filter System to Auxiliary Faucet:
NOTE: Installing a seperate Faucet for Filtered Water (DuPont WFFT100 Series) optimizes filter life and
provides contaminant reduction.
HOT WATER
VALVE
COLD WATER
VALVE
HOT WATER
VALVE
COLD WATER
VALVE
1
STEP
2
STEP
Safety glasses and a respirator are
recommended for this process, as it may
produce dust that can cause severe
irritation if it is inhaled or comes in contact
with eyes.
DO NOT DRILL THROUGH AN ALL-PORCELAIN OR CAST IRON SINK. If installing on an all-porcelain or
cast iron sink, the faucet must be mounted in a pre-drilled sprayer hole or through the countertop next
to the sink. If the countertop must be drilled, make certain that the area below the drilling location is
free of wiring and pipes. Also, make sure that there is sufficient room to make the proper connections
to the bottom of the faucet mount. DO NOT DRILL THROUGH COUNTER TOPS MORE THAN 1” IN
THICKNESS OR COUNTER TOPS MADE OF TILE, MARBLE, GRANITE, OR SIMILAR SUBSTANCE.
Consult with a plumber or counter top manufacturer for assistance.
NOTICE
CAUTION
PURCHASED
SEPARATELY