Instructions / Assembly
STEP
Mount the Faucet for Filtered Water
2
NOTE: The Faucet for Filtered Water in this package is designed to fit a 9/16" hole. Most standard sinks come with 1-3/8"
or 1-1/2" diameter water sprayer holes that can be used for mounting the Faucet. If the pre-drilled holes cannot be used or
are not in the desired position, a new hole must be drilled using either a 9/16" or 5/8" drill bit to accommodate the Faucet.
The Faucet for Filtered Water base should be positioned securely on a flat surface with adequate space for proper function.
Consider convenience and appearance of the faucet before installation.
IF YOUR SINK DOES NOT HAVE A WATER SPRAYER HOLE, GO TO
. IF YOUR SINK DOES HAVE A WATER SPRAYER HOLE,
GO TO
.
CAUTION
CAUTION
NOTE: Do not tighten the Faucet for Filtered Water Stem Nut with pliers as it may strip the Faucet Stem threads.
NOTE: Make sure that the Faucet for Filtered Water is assembled. The Faucet for Filtered Water Spout should be inserted into
the Faucet for Filtered Water Body and the retaining nut should be tightened until snug.
FAUCET FOR
FILTERED WATER
SPOUT
BASE
2