Service manual

3 FOLDING SECTION
3-16
DUPLO DF-755 86V-M12D0-0
3.2.2 Removing the half nut of the second folding plate
1) Remove the second folding plate.
2) Remove the rough adjustment knob using the L-type wrench.
[1]
FR screw ................................................... 2
[2]
Rough adjustment knob
3) Remove the lock lever.
[3]
Screw
[4]
Lock lever
4) Remove the top cover.
[5]
Screw ......................................................... 4
[6]
Top cover
5) Remove the fine adjustment knob and bearing from the second folding plate.
[7]
FR screw ................................................... 2
[8]
Fine adjustment knob
[9]
Bearing ...................................................... 1
6) Remove the stopper from the second folding plate.
[10]
Screw .........................................................
2
[11]
Stopper
7) Remove the guide block unit from the screw shaft.
[12]
Guide block unit .......................................
1
Note
When putting the guide block unit back to the screw shaft, make sure that the bearing of
the guide block unit comes to the fine adjustment knob side.
8) Remove the compression spring and take out the half nut from the compression spring.
[13]
Compression spring ..................................
1
[14]
Half nut .....................................................
1
Note
When reattaching the removed parts of the folding plate, you need to adjust the folding
stopper and rough adjustment knob.
Refer to “CHAPTER 5>2.2 Adjusting the Folding Plate."