Service manual

3 FOLDING SECTION
3-15
DUPLO DF-755 86V-M12D0-0
3.2 Folding Plate Section
3.2.1 Removing the half nut of the first folding plate
1) Remove the first folding plate.
2) Remove the rough adjustment knob.
[1]
FR screw .....................................2
[2]
Rough adjustment knob
3) Remove the top cover.
[3]
Screw ......................................................... 5
[4]
Top cover
4) Remove the fine adjustment knob and bearing from the first folding plate.
[5]
FR screw ................................................... 2
[6]
Fine adjustment knob
[7]
Bearing ...................................................... 1
5) Remove the stopper from the first folding plate.
[8]
Screw ......................................................... 2
[9]
Stopper
6) Remove the guide block unit from the screw shaft.
[10]
Guide block unit .......................................
1
Note
To put the guide block unit back to the screw shaft, make sure that the bearing of the
guide block unit comes to the fine adjustment knob side.
7) Remove the compression spring and take out the half nut from the compression spring.
[11]
Compression spring ..................................
1
[12]
Half nut .....................................................
1
[1]
[2]
[8]
[4]
[9]
[3]
[5]
[7]
[6]
[10]
[11]
[12]
[3]
[3]
Note
When reattaching the removed parts of the folding plate, you need to adjust the folding
stopper and rough adjustment knob.
Refer to “CHAPTER 5>2.2 Adjusting the Folding Plate."