95M-200 GAS-FIRED DIRECT VENT MODULATING HOT WATER BOILER Pff'J 240006106 Re,z I I [05/06]
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. A. This appliance does n have a pilot. It is equipped with an ignition device which automatically lights the burner. Do not try to light the burner by hand. B. BEFORE OPERATING smell aal around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and wiRRsettle on the floor.
1.STOP!Readthe safetyinformationabovein this manual. 2. Set the thermostatto the lowestsetting. 3. Turnoff all electricpowerto the appliance. 4. This applianceis equippedwith an ignitiondevicewhich automaticallylightsthe burner.DO NOTTRYTO LIGHTTHE BURNER BY HAND. 5. Removethe frontjacket panel. 6. Turnthe gas controlvalveclockwisef_ the valve should be perpendicular to "OFF". The handle of to the pipe in the "OFF" position. Control 'Valve "ON" Control 'Valve "OFF" 7.
12. If the appliancewill not operate,follow the instructionsunder "ToTurnOffGasToTheAppliance"andcallyourservicetechnician or gas supplier. 1.Turn off all electricpowerto the applianceif serviceis to be per° formed. 2. Set the thermostatto the lowestsetting. 3. Removethe frontjacket panel. 4. Turnthe gas controlvalveclockwisef_ the valve should be perpendicular 5. Replace the front jacket to "OFF". The handle of to the pipe in the "OFF" position. panel.
Regular service and maintenanceby a qualified serviceagency must be performed at least once every 12 months (preferably at the start of each heating season) to assure safe, trouble free operation and maximum efficiency. The boiler owner SHOULD NOT attempt these procedures. This annual service should include at a minimum: o Examining the flue passages between er, and condensate lines, and cleaning o Inspecting essary. o Placing the boiler in operation procedure. o Inspecting sary.
MONTHLYDURINGHEATINGSEASON: . 2. Remove jacket front and top panels and check for piping leaks around relief valve and other fittings. If found, contact a qualified service agency. DO NOT USE STOP LEAK COMPOUNDS. Test relief valve. Refer to valve manufacturers packaged instructions with relief valve. 3. Visually inspect the venting and air intake er operation.
