Operation Manual

ManualsBrandsDunavox ManualsCooling FreezingDAB-89.215DB

Code Rev. D 20140818 (IEC)

LIGHT

Used to turn the inner light on/off.

Used to increase (warm) the set temperature by

1°C/1ºF.

DOWN

Used to decrease (cool) the set temperature by

1°C/1ºF.

Display

Display the digital temperature and service

indicators.

Indicator Light

The indicator light is located at the right lower corner

of the display. The indicator light will be on when the

multi-key function is selected. To perform the multi-

key function, press and hold the first key, then press

the rest key for at least 5 seconds and then release

all the keys.

ºF/ºC Selector

Select the temperature display setting in Fahrenheit

or Celsius degree. To change the temperature from

Fahrenheit to Celsius or from Celsius to Fahrenheit,

press and hold the LIGHT key for 5 seconds.

Key Lock (Only for models with outside controls)

If in 2 minutes or longer without pressing any key,

the key lock will be activated automatically. To

remove the lock, press the UP and DOWN keys at

the same time for at least 5 seconds and the

indicator light will flash three times to confirm the

action.

Setting the Temperature Control

 The unit has single temperature zone. The

temperature can be set between 5ºC and 22ºC

(41ºF and 72ºF) which is ideal for storing red,

white or sparkling wine.

 When the unit is plugged in for the first time, the

unit will power up automatically to the preset

defaults. The temperature preset at the factory

is 12°C (54ºF).

 You can set the temperature as required by

pressing the UP or DOWN key. When you

press the two keys at the first time, the display

will show the last temperature set previously.

The temperature will increase 1°C/1ºF if you

press the UP key once, or the temperature will

decrease 1°C/1ºF if you press the DOWN key

once. The display flashes while you make the

setting.

 After the temperature has been set, the display

shows the current inner temperature.

 To view the set temperature at any time, press

the UP or DOWN key, the set temperature will

temporarily ﬂash in the display for 5 seconds.

Then the display shows the current inner

temperature again.

USE AND CONTROL – DUAL ZONE

The Controls of Your Unit

POWER

To turn the appliance on/off, press and hold the

key for 5 seconds until themperature display lights

up or goes out.

NOTE: Pressing the key once can switch off the

audible alarm when the alarm is on.

To increase (warm) the set temperature by 1°C or

1ºF.