Instruction manual

�17�
INSTRUCTION MANUAL
4�Slowly pull out the harness
M
at the left door corner,
Figure7
14
13
which must be ensured no longer than 90mm to
avoid loosen the inside terminals� Insert the harness
wires one by one into the upper left hinge hole
through its gap� See Figure 7�
3rd step – Tidy the Cabinet� See Figure 8�
1� Loosen the 2 screws to take out the harness cover
O
from the top left side of the
cabinet�
2� Install the harness cover at the top right side of the cabinet to cover the harness
there�
3� Install the bottom hinge at the bottom left side of the cabinet with 4 screws
�
Figure8
1b
15
1b
15
1b
7
3b
1b
15
1b
1b
15
7
3b
Mounting Bar
4th step – Install the Door� See Figure 9�
1� Install the upper left hinge
N
at the top left side of the cabinet with 3 screws �
2� Fix the door to the bottom hinge with a screw
H
�
3� Connect the two wiring harnesses
M
&
Q
through their terminals�
4� Tidy the harnesses and install the upper left hinge cover
P
with the screw �