Instruction manual

�16�

INSTRUCTION MANUAL

2nd step – Tidy the Door�

1� Pull the harness wires one by one out of the upper

Figure2

right hinge hole through its gap, and remove the

upper right hinge (Disused)� See Figure 2�

2� Tidy the harness and carefully push back it into the

Figure3

door frame, and cover it with the right door corner

cover

� See Figure 3�

Remarks:

If it is difficult to push back the harness into the door frame, please follow the steps in

Figure 4 & 5�

Figure4

Figure5

1 Remove the gasket at the upper inner side of the door to expose the display back

cover�

2� Carefully prize up the back cover by a straight screwdriver� Then slowly draw the

harness into the door frame� and tidy the gasket�

3� Insert a straight screwdriver to the groove of the left

Figure6

door corner cover

, and prize it up� See Figure 6�