Specifications

Installation & Operation Manual for Flexible Batch Broiler
Australian Units
24
D. TROUBLESHOOTING
SYMPTOM CAUSE REMEDY
Control display does not light up No power
Ensure broiler is plugged into a proper
voltage/Hz receptacle (per name plate
rating) and receptacle as power. Check
dedicated circuit breaker.
Raw or undercooked product with no
controller error messages displayed.
Product not loaded properly. Review loading technique.
Product button was depressed prior to
loading product.
Ensure product button is depressed
immediately after product is loaded into
broiler.
Wrong product button was depressed.
Ensure proper product button is being
depressed.
Lower burner not lighting properly.
(Observe bottom burner through slits in
lower grease tray)
If broiler is hot, attempt to clean burner in
place with broiler cleaning tool.
If broiler is cold or allowed to cool down,
remove lower burner by removing access
panels, clean, and reinstall. Remove
lower ame sensor and clean with a soft
cloth & isopropyl alcohol.
Infrared burners not lighting properly.
(Observe Infrared through discharge end of
broiler. Note: Burners should remain lit in
idle mode
Remove upper control compartment
panel and clean 2 upper ame sensors
with a soft cloth & isopropyl alcohol.
Clean ame sensor tube with ame
sensing tube cleaning brush.
Conveyor belt will not move to
discharge product.
Conveyor belt is being obstructed
Observe for obstructions by manually
rotating conveyor belt from discharge
end of broiler using broiler cleaning tool.
Ensure discharge scraper is properly in
place.
Ensure docking plate is properly in place.
Ensure ame arrestor is properly in
place.
Loader is not able to be pushed
completely into cooking chamber
Docking plate is not properly in place.
Ensure docking plate and locking tab are
correctly in place.
Product is getting stuck or mangled
upon loading
Docking plate is not properly in place
Ensure docking plate and locking tab are
correctly in place.
Flame arrestor is not properly in place
Ensure ame arrestor is correctly in
place and tabs are slotted correctly.