Specifications

Installation & Operation Manual for Flexible Batch Broiler

Australian Units

C-4. Monthly Cleaning

DO NOT

LOAD

IF LIGHT ON

Remove top panel by

lifting up and out.

Locate the two ame sensors

for the Infrared burners.

With the broiler cool, remove

sensor by pulling on the black

covering near the ceramic.

Do not pull on the wire

to remove.

Clean the tip of the sensor up to the rst

ceramic with alcohol pad. Replace the

sensor. Take care to insert the sensor

all the way into the tube so the metal

retaining clip is no longer exposed.

With the broiler cool, remove the

rear panel of the broiler and remove

the sensor for the lower burner.

Follow the same procedures as

those for the top sensors.

After the sensor is removed take the T-handled

cleaning rod and carefully run the brush through the

Flame Sensor Tube. Push and pull the brush through

each tube a few times to make sure it is clean.