Specifications

11
Installation & Operation Manual for Flexible Batch Broiler
Australian Units
D. ADJUSTMENTS AT INSTALLATION
Each broiler section and all its component parts have
been tested thoroughly and inspected before your broiler
was shipped from the factory. However, it is sometimes
necessary to further test or adjust the broiler once it has
been installed. Such adjustments are the responsibility
of the Dealer or Installer. These types of adjustments
are not considered defects, rather a normal and routine
part of the proper installation of the equipment.
These adjustments include but are not limited to:
• Adjustments to the gas pressure regulator
• Broiler height adjustment (if required)
No installation should be considered complete
without proper inspection and, if necessary, any
adjustments by qualified service or installation
personnel.
It is also important not to obstruct the natural ow
of combustion and ventilation air if the broiler is to
operate properly. This broiler should not be installed on
a curb base or sealed to the wall. Either condition can
restrict the ow of air to the combustion compartment
or prevent proper ventilation of the unit. Before making
any connections to the broiler, check the ratings plate
to be sure the broiler specications concur with the type
of gas and voltage to be supplied to the broiler.
The rating plate is located on the back of the control
compartment cover panel on the right end of the
unit.
The plate bearing the broiler’s model number and serial
number is attached to the back side of the unit.
Support broiler here
Raise or Lower Broiler
The broiler height can be adjusted via two screws on
each leg.
Caution: The Broiler is very heavy!
Use adequate help for lifting.
1. Lift one end of the broiler onto a wide, sturdy stand
(not supplied).
2. Remove (2) screws per leg and raise/lower to
threaded holes. Reinstall screws.
3. Remove stand and safely raise/lower broiler.
4. Place plastic hole plugs (supplied attach to stand)
in any unused holes.
Screw
Screw
Slide Leg.
Reinstall screws.
Plastic Hole Plug