Service manual

27
Service Manual for Flexible Batch Broiler Units
DRIVE CHAIN DEFLECTION ADJUSTMENT
The Drive Chain connects the drive motor to the
Conveyor.
1. Check that the deection in the Drive Chain does
not exceed 3/16″ inch maximum. If the chain
requires adjustment, proceed to step 2.
2. Remove Discharge Access Panel. Refer to the
COVERS and PANELS section of the manual.
3. Remove Conveyor Drive Motor Cover.
4. Loosen the four screws securing the motor mount
to the frame.
5. Move the motor mount up or down as necessary
to provide 3/16″ deection at center of chain.
6. Secure the motor mount in place by tightening the
four motor mount screws.
7. Install Conveyor Drive Motor Cover.
8. Install Discharge Access Panel.
INSIDE VIEW
Motor
Mount
Screws
Drive Chain Deection
CONVEYOR POSITION ADJUSTMENT
The Conveyor position is adjusted by adding shims
between the Conveyor Shaft Bearing and the frame.
1. Remove Discharge Hood to provide visual access
to the Conveyor.
2. Adjust Conveyor height as described in the
following illustration.
3. Remove the two screws securing the bearing to
the frame.
4. Insert shims as necessary between the bearing
assembly and the frame.
5. Check Conveyor position.
NOTE: Leading edge of Discharge Chute should be
about an 1/8″ above the center line of the Conveyor
shaft. When correctly adjusted, the Conveyor link
should just graze the backside of the chute. If adjusted
too high, the link will roll over the top of the leading
edge of the Discharge Chute causing a Conveyor jam.
6. If additional shims are required, repeat step 4.
NOTE: Additional shims are located inside the Drive
Motor Cover.
7. Run Conveyor for several full revolutions to conrm
that no jamming occurs.
Discharge
Chute
Conveyor
Shaft
Position 1/8" above
center line of
conveyor shaft.
Conveyor Discharge Shaft Adjustment