Service manual

19
Service Manual for Flexible Batch Broiler Units
8. Remove the Main Grease Pan and V Grease Pan.
9. Remove Front Panel. Refer to the COVERS and
PANELS section of the manual.
10. Disengage J Burner bracket from stud at discharge
end, and move J Burner toward discharge end to
disengage from its orice.
11. Carefully slide J Burner Assembly out of front
of broiler, taking care not to damage the Igniter
Assembly.
Air Box
Mounting Plate
Gas
Connection
Infrared Burner Assembly
12. Reverse procedure to install a new J Burner
Assembly.
NOTE: Be sure J Burner input end engages the gas
orice and that the discharge end of the J Burner sits
securely in the burner bracket.
Air
Shutter
J Burner
Input
End
Lower J Burner Assembly
Ignition Modules
The Ignition Modules are accessible by removing
the Lower Control Side Service Panel. The Ignition
Modules are at the bottom of the compartment behind
the Relays.
WARNING
DISCONNECT THE ELECTRICAL POWER
TO THE BROILER AND FOLLOW
LOCKOUT / TAGOUT PROCEDURES.
1. Remove the Lower Control Side Service Panel.
Refer to the COVERS and PANELS section of the
manual.
2. Tag and disconnect the wires to the Ignition Module
to be removed.
3. Disconnect the Flame Sensor wire/s.
4. Remove the two screws attaching Ignition Module
to frame and remove the module.
5. Reverse this procedure to replace an Ignition
Module.