Service manual

Service Manual for Flexible Batch Broiler Units
14
Conveyor Drive Chain
The Conveyor Drive Chain connects the drive motor
to the Conveyor.
WARNING
DISCONNECT THE ELECTRICAL POWER
TO THE BROILER AND FOLLOW
LOCKOUT / TAGOUT PROCEDURES.
1. Remove Conveyor Drive Motor Cover. Refer to
the COVERS and PANELS section of the manual.
2. Remove Discharge Access Panel. Refer to the
COVERS and PANELS section of the manual.
3. Disconnect motor wires.
4. Remove four screws securing motor mounting
plate.
5. Raise motor mounting plate to disengage drive
chain from motor sprocket.
6. Disengage chain from conveyor sprocket.
7. Remove chain from broiler by removing the master
link.
8. Reverse procedure to install a new chain.
NOTE: When installing the new chain, be sure to
engage the chain on the motor sprocket and conveyor
sprocket. Then adjust the tension on the chain to allow
3/16″ chain deection, as described in the procedure
DRIVE CHAIN DEFLECTION ADJUSTMENT in
the ADJUSTMENT Section, before tightening the
motor mounting plate screws.
Conveyor
Sprocket
Motor
Sprocket
Chain
Drive Chain and Sprockets
Conveyor Drive Motor Sprocket
The Conveyor Drive Motor Sprocket is attached to
the motor shaft.
WARNING
DISCONNECT THE ELECTRICAL POWER
TO THE BROILER AND FOLLOW
LOCKOUT / TAGOUT PROCEDURES.
1. Remove Conveyor Drive Motor Cover. Refer to
the COVERS and PANELS section of the manual.
2. Remove Discharge Access Panel. Refer to the
COVERS and PANELS section of the manual.
3. Disconnect the motor wires.
4. Remove the four screws securing motor mounting
plate.
5. Raise motor mounting plate to disengage drive
chain from motor sprocket.
6. Disengage drive chain from motor sprocket.
7. Loosen the two setscrews on motor sprocket and
remove sprocket from motor shaft.